CTC Union SHDSL Bedienungsanleitung PDF herunterladen (Seite 91)

5.4.2. Configure SHDSL parameters

This section shows how to setup the SHDSL parameters: SHDSL Mode, Annex type, Psd Mask, SNR margin.

Select Shdsl, and press [ENTER] or [RIGHT].

Setup SHDSL Parameter, Mode

Press [TAB] to select the operating type and press enter to finish setting.

The SHDSL modes have three types: STU-R, STU-C-INTCLK and STU-C-EXTCLK

INTCLK: The device will generate the appropriate clock speed defined by the speed setting of the interface.

EXTCLK: The device will accept the clock from the interface and will use that clock to receive and transmit data across the

interface.

Most point-to-point applications use Internal Clock. If the DTE provides a clock with TX data, the clock can be set to External

Clock.

For Ethernet interface model, since Ethernet does not provide a clock, the correct setting for CO side NTU should always be

STU-C-INTCLK.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 161 162

Keine Kommentare

CTC Union SHDSL Bedienungsanleitung Seite 91