CTC Union ETU01C Bedienungsanleitung PDF herunterladen (Seite 16)

ERM01-FE1/Data

Fractional E1 to Data Card

The high-speed data cards are available in two E1 types; one for fractional E1 and one for Unframed E1 (transparent) and with

data communication interfaces for V.35, RS-530, X.21 and RS-449(V.36). All line cards come with adapter cables that terminate in the

appropriate user interface for DCE. Simple DIP Switch settings provide all the control for E1 and Dataport settings. When the ERM01 is

equipped with optional SNMP, centralized management can configure and monitor the card and performance without manual DIP setting.

Unframed E1

with adapter

●

HS (up to 2Mb/s) Serial interface card for serial transport over G.703 E1.

DIP switch or SNMP managed (Optional)

Hot swappable without effecting any other line card

Front panel pushbuttons to activate loop testing with integral 511

pattern BERT.

LED status indicators for E1 Signal, Sync and Dataport TD, RD, and CD.

Features

Compliant with ITU-T standards for V.35, RS-530, X.21 and V.36

Synchronous transmission at Nx64 data rate (2.048M for Unframed)

Line code: NRZ

Control Signals: CTS always ON

Specifications

●

Cable Adapter :

HDB26M to MB34F for V.35

HDB26M to DB25F for RS-530

HDB26M to DB37F for RS-449(V.36)

HDB26M to DB15F for X.21

ERM01-E1U/ET100R

Unframed E1 to 10/100Base-TX

Ethernet Router Card

Unframed

The ERM01-E1U/ET100R Router Card is a single slot card that can be installed in any available slot to provide IP over E1 transmission. The

router engine uses an embedded system which can be configured and controlled from a serial port, Telnet or Web based user interface. It

supports industry standard encapsulations of PPP and HDLC as well as proprietary header for Cisco router's HDLC.

●

Features

Ethernet port IP Address/subnet mask

WAN port IP Address/subnet mask

Router Name / Password

RS-232 Console Port Management

Web/Telnet Management

WAN port IP address/subnet mask

DHCP server/client

NAT Function

Virtual Server Mapping

SNMP MIB-2 supported

Supports VPN pass through

Forwarding IP multicast support

DNS proxy server

SNTP supported

Simple Statistical

Ping and Trace route

Static Routing Setup

Routing Table (manually set up to 32 entries minimum)

Dynamic Routing RIP I & II, Send or Receive on Ethernet or WAN

PPP, HDLC and Cisco HDLC WAN protocol encapsulatoin

Flash Upgrade (via TFTP)

Hardware

Connection

WAN Speed

LAN Speed

Function

Protocols

Security

LED

Samsung ARM9 integrated communications

166MHz processor, 8MB Flash, and 32MB

pipeline RAM for code, data and buffers

1 x Ethernet LAN port (10/100)

Synchronous Port 2048Kbps

Ethernet LAN port 10/100 Mbps

Proxy Routing, IP Routing, Static Routing,

Dynamic Routing, DHCP Client/ DHCP

Server, IP Mapping, Packet Filtering

PPP, NAT, RIP 1/2, TCP/IP

PAP/CHAP, NAT, Filter

Link/ACT : On=link ; Flash=Activity

100 : On=100Base ; Off=10Base

FE1/ET100 :

FE1/ET100R :

FE1/V35 :

FE1/RS530 :

FE1/RS449 :

FE1/X21 :

FE1/RS422 :

FE1(N64) to 10/100Base-T/Tx Ethernet Bridge

FE1(N64) to 10/100Base-T/Tx Ethernet Routing

FE1(N64) to V.35 with cable adapter

FE1(N64) to RS530 with cable adapter

FE1(N64) to RS449 with cable adapter

FE1(N64) to X.21 with cable adapter

FE1(N64) to RS422 with cable adapter

Ordering Information

5-5

E1 CSU/ DSU Slide-in Card

ERM01-FE1/Data

www.ctcu.com

Table of Contents

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

CTC Union ETU01C Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Netzwerkmedienkonverter CTC Union ETU01C