CTC Union IPM-4SE Spezifikationen Seite 1

IPM-4SE 4-Port E1 IP Multiplexer

Chapter 2 Installation Chapter 2. Installation 2.1 Introduction The Installation chapter will cover the physical installation of the IPM-4SE, 4-Port

Chapter 2 Installation 2.5 Electrical Installation With an AC power model, AC power is supplied to the IPM-4SE through a standard IEC C14 3-prong

Chapter 2 Installation 12 2.7 Basic Configuration and Diagnosis The IPM-4SE units are shipped in pre-configured pairs. One is labeled CO (central of

Chapter 3 Configuration and Operation Chapter 3. Configuration and Operation 3.1 Description IPM-4SE consists of the front panel and the rear panel.

Chapter 3 Configuration and Operation 3.3 Rear Panel Introduction There are three parts to the rear panel of the IPM-4SE, shown in Figure 3.2.

Chapter 3 Configuration and Operation 15 3.7 Fault Report The alarms/status of NE node can be reported thru RS232 or Telnet (CLI command). The resou

Chapter 3 Configuration and Operation 16 CLI Command Descriptions CLICommand DescriptionsSystemCommandslogout LogoutfromtheCLISystemcdis

Chapter 3 Configuration and Operation 17 CLICommand DescriptionsProvisioningCommandsgciInitializeGCIMiddleWare&CESoPSNchipInitiali

Chapter 3 Configuration and Operation 18 3.10 Factory Default Scripts When delivered from the factory, the units are paired as CO and CPE for immedi

Chapter 3 Configuration and Operation 19 3.10.3 CPE Unit Factory Default Script CPE default, replace xx:xx:xx with CO unit's unique MAC address

Chapter 3 Configuration and Operation 20 3.11 Application Examples 3.11.1 Point-to-Point with single E1 (port1) and LAN port active. CO Side: (use

Chapter 3 Configuration and Operation 21 CPE Side: (use the correct MAC address for the local CO unit) gci srcnet 172.16.1.2 255.255.255.0 ipset 19

Chapter 3 Configuration and Operation 3.11.4 Using the IPM in a Routing Environment The IPM-4SE is designed for use in an Ethernet environment (Laye

Appendix 23 Appendix Abbreviations AC Alternating Current AIS Alarm Indication Signal ANSI American National Standards Institute AP Acce

Appendix 24 This page left blank intentionally.

LEGAL The information in this publication has been carefully checked and is believed to be entirely accurate at the time of publication. CTC Union

CTC Union Technologies Co., Ltd. Far Eastern Vienna Technology Center (Neihu Technology Park) 8F, No. 60, Zhouzi St. Neihu, Taipei, 114 Taiwan Phon

Table of Contents i CHAPTER 1. INTRODUCTION ...

Table of Contents ii

Chapter 1 Introduction 7 Chapter 1. Introduction 1.1 Welcome In telecommunications, TDM over IP (TDMoIP) is the emulation of time-division multiplex

Chapter 1 Introduction 1.4 Physical Appearance Figure 1.1 IPM-4SE 4-Port E1 Physical Appearance Important: T1(DS1) is currently not support

Chapter 1 Introduction Power Supply AC: 100~240V ± 10%, 47 ~ 63Hz (Optional) DC: -18 ~ -75 V Power Consumption: less than 10W Operating Envir